0 Replies Latest reply: Mar 13, 2015 7:17 AM by ACC6204843 RSS

    SB200-100 IR output signal

    Visibility: Open to anyone

      Anyone know what the output signal should be out of the remote IR jack?

      My software remote control quit working, I have done a full reset and remote reprogram.

      Not getting any IR flash out of the blaster when key press the remote on the screen.

      Was working at one time.

      Wondering if the IR jack is a 1 or a 2 circuit jack, the blaster I have is a 2 circuit and does show ohms between tip and middle ring.